Created with Sketch. Created with Sketch.

Shop by Category

Antiques & Collectibles

  • Armstrong NO 2S Straight Lathe Toolholder

    Armstrong NO 2S Straight Lathe Toolholder

    Here is a gently used Armstrong 2 S straight toolholder for 3/8 square cutter bits. It has a shank that measures approximately 5/8" wide and 1 3/8" tall.  it is ready to go to work or play with your next machining project. Will ship to US addresses,...

    $30.00
    Add to Cart
  • Bancroft Air Force? Hat

    Bancroft Air Force? Hat

    Here is a gently used Bancroft Air Force Hat we believe. Check your literature to be certain. It is good condition and may need cleaning. Any questions, please ask! Payment due in 5 days.

    $20.00
    Add to Cart
  • Control Transformer 25 Volt early machine age

    Control Transformer 25 Volt early machine age

    Here is a vintage control transformer. It has a 115 volt primary and mounts to a standard metal junction box. It weighs 5 3/4 pounds and the core stack  measures 3 1/2x3x2 13/16. When connected to 115 volts it puts out as shown in the photo.Will...

    $15.00
    Add to Cart
  • Crosby 12 inch cast iron Gin Pulley

    Crosby 12 inch cast iron Gin Pulley

    Here is a barn fresh old cast iron 12 inch Crosby lifting "gin" pulley made for what looks to be 1" rope. It shows no signs of abuse and turns freely. It weighs about 14 pounds and measures 14"x17"x3" and we will ship best way. Contact us before payment...

    $45.00
    Add to Cart
  • Dyke's Automobile and Gasoline Engine Encyclopaedia

    Dyke's Automobile and Gasoline Engine Encyclopaedia

    Here is a great piece of automotive history and and an excellent referrence book for those restoring antique cars, trucks and tractors. This is the twentieth edition of the Dyke's Automobile and Gasoline Engine Encyclopaedia published in 1945. It is full...

    $55.00
    Add to Cart
  • Economy Engine 1.5HP satarting crank 177F

    Economy Engine 1.5HP satarting crank 177F

    Here is a starting crank for an antique Hercules? or Economy 1.5HP stationary engine. it has a 2 5/16" hile probably to accomodate a 2 1/4" crank and is marked "177F". Check your shaft size and parts book to be sure this is the right one for you. May fit...

    $35.00
    Add to Cart
  • Looks like new NO 080 Williams Agrippa Boring Toolholder

    NO 080 Williams Agrippa Boring Toolholder

    Here is a great piece of tooling for the small lathe. It is a like new Armstrong NO 080 Agrippa boring toolholder. It accepts varying boring bar sizes by turning the clamp over. It has no previous owner markings and no evidence of use. There are not the...

    $56.00
    Add to Cart
  • Snap On 1/4" Drive 9/32 12 point deep socket MVS 9

    Snap On 1/4" Drive 9/32 12 point deep socket MVS 9

    Here is a sharp looking gently used Snap On 1/4" drive 12 point deep socket # MVS 9. Not abused, looks like hardly used. No previous owner marks. Ready to work or play. Will ship postpaid to US addresses, payment due in 5 days,Any questions, please ask!...

    $10.00
    Add to Cart